Assembly Instructions

Cage Assembly instructions

Tools: Phillips Screwdriver

Time: 20 Min’s average.

Important-Read all instructions before beginning.

If at any time you have any questions, please call 1-616-850-0432

It is best to assemble on a flat hard surface. Keep top edges FLUSH while assembling.

When installing screws, make sure that you put them in straight.

Also countersink screws so they are flush. Screw covers are provided.

Heat Panels MUST be used with a temperature controller.

All panels are marked with numbers and letters and they are on the outside of the cage when assembling.

Step # 1- Take part #1 and stand on edge with arrow pointing up.

Step # 2- Take part #2 and stand on edge with arrow pointing up.

               Butt letter A on part #1 to letter A on part #2. Make sure top edge  

               is flush. Install screws in holes provided on part #1 into part #2.                                          

Step # 3- Take part #3 and stand on edge with arrow pointing up. Butt letter B

               on part #2 to letter B on part #3. Make sure top edge is flush. Install

               screws in holes provided on part #3 into part #2.

Step # 4- Take part #4 and stand on edge with arrow pointing up. Butt letter C

               to letter C and letter D to letter D. Make sure edges are flush. Install

               screws on part #1 into part #4. Then install screws on part #3 into

               part #4.

Step # 5- Install Back panel

                 The wires from the light, heat panel and thermostat probe come out of the grooves

                 provided. If your probe wire is bigger then the slot provided, you can drill a new hole

                and use an utility knife to cut the remaining piece of material out.

                Then install screws on all 4 sides.

Step # 6- Flip cage over and  Install front face with letter  ( T ) closest to the light.

               Then install screws on all 4 sides in holes provided.

Step # 7- Apply all screw covers provided for screws. Remove all tape. Stand cage

               upright with light in the air. If you wish to seal your cage now would be the

               time to do it. Purchase a quality Clear Kitchen and Bath Silicone and follow

               directions on tube.

Step # 8- Install perches. End caps on PERCHES ARE ADJUSTABLE. Adjust perches to fit and install.

Step # 9- Install glass doors. Plug in your light and heat panel.

Step # 10- Enjoy your purchase!